New paper: high-resolution measurement of local power peaking in a research reactor core
Read the paper in Annals of Nuclear Energy
G. Gabrieli, H. Abuzlf, U. Steinitz, K. Barda, K. Ben-Meir, L. Danon, A. Krakovich, O. Aviv, S. Gurevich, Z. Yungrais, E. Gilad, I. Neder, "High-resolution, depth-resolved measurement of local power peaking induced by flux traps and control blades in an MTR core", Annals of Nuclear Energy (in press), article 113014, 2026. DOI: 10.1016/j.anucene.2026.113014
The power peaking factor (PPF) is a key safety parameter in the design, commissioning and operation of research reactors, and it often limits the reactor power. In pool-type reactors, water gaps in the core act as local thermal flux traps that enhance fission in the adjacent fuel, while control blades and reflectors also reshape the local power distribution. These effects are hard to calculate, since they depend sensitively on the core geometry and the burnup distribution, so experimental validation is essential for quantifying the calculation uncertainties.
This joint study of Soreq NRC and the Unit of Nuclear Engineering and Klein Institute at BGU reports the second experimental campaign at the IRR-1 reactor. A fresh fuel assembly was irradiated for four hours in a dedicated core configuration, next to a flux trap, control blades and a graphite reflector. After a week of cooling, gamma rays from short-lived fission products were measured across the assembly surface at 3 mm resolution. Since gamma lines of different energies penetrate to different depths, the measurements resolved the power distribution at several depths within the assembly. The measured PPF was 1.48 to 1.58, depending on the scan side and gamma line, in good agreement with high-fidelity Monte Carlo calculations (1.44 to 1.55), compared with 1.25 measured in the previous campaign on a 58 percent depleted assembly. The results provide a benchmark for code validation, and show that significant intra-assembly power peaks can arise under realistic operating conditions and should be accounted for in reactor safety requirements.

The IRR-1 research reactor core at Soreq NRC and its simulation model.
Keywords: reactor physics, research reactor, IRR-1, Soreq NRC, power peaking factor, gamma spectroscopy, Monte Carlo