Yevgeny Rakita

The (opto)electronic behavior of semiconductors depends on their (quasi-)free electronic carrier densities. These are regulated by semiconductor doping, i.e., controlled “electronic contamination”. For metal halide perovskites (HaPs), the functional materials in several device types, which already challenge some of the understanding of semiconductor properties, this study shows that doping type, density and properties derived from these, are to a first approximation controlled via their surfaces. This effect, relevant to all semiconductors, and already found for some, is very evident for lead (Pb)-HaPs because of their intrinsically low electrically active bulk and surface defect densities. Volume carrier densities for most polycrystalline Pb-HaP films (<1 µm grain diameter) are below those resulting from even < 0.1% of surface sites being electrically active defects. This implies and is consistent with interfacial defects controlling HaP devices in multi-layered structures with most of the action at the two HaP interfaces. Surface and interface passivation effects on bulk electrical properties are relevant to all semiconductors and are crucial for developing those used today. However, because bulk dopant introduction in HaPs at controlled ppm levels for electronic-relevant carrier densities is so difficult, passivation effects are vastly more critical and dominate, to first approximation, their optoelectronic characteristics in devices.